Thermal behavior and kinetics of heavy crude oil during combustion by high pressure differential scanning calorimetry and accelerating rate calorimetry

Abstract

© 2019 Elsevier B.V. Because the thermal release correlates directly with the success of in-situ combustion (ISC) technology, this research performs a series of investigations concerning thermal behavior and kinetics of heavy crude oil during combustion using high pressure differential scanning calorimetry (HP-DSC) and accelerating rate calorimetry (ARC). The results obtained from HP-DSC profiles indicated that for oil alone and its mixtures with quartz sand/crushed core, the peak temperature was lowered, and the heat flow increased with increasing oxygen partial pressure. The heat enthalpy of low temperature oxidation (LTO) was higher than that of high temperature oxidation (HTO) under oxygen partial pressures of 0.5, 1 and 1.5 MPa, and the increase in heat enthalpy of LTO with oxygen partial pressure was more pronounced than that of HTO. Unlike the crushed core, the addition of quartz sand delayed exothermic oxidation reactions. Compared with oil only and oil + quartz sand, the LTO and HTO peak temperatures of oil + crushed core were considerably lowered, and the effect of crushed core on increasing heat release for LTO at oxygen partial pressure of 1.5 MPa was more prominent. It was observed that the heat enthalpy of LTO and HTO increased quasi-linearly with the oxygen partial pressure in both the presence and absence of quartz sand/crushed core. ISC might be considered as an appropriate candidate for Jiqi block, based on exothermic continuity of the ARC curves, with the near-wellbore zone of target block heated to 180 °C where the exothermic oxidation activity is notably intensified. The kinetic results showed that the LTO and HTO intervals were divided into 6 and 2 subintervals, respectively, which facilitated more precise modelling of the ISC process.